How to put a ride-on mower in a service position

Ride-on mower R200-series; service position

1. Put height adjustment lever in service position
2. Engage parking brake
3. Bring starter key with attached tool
4. Remove cover
5. Disconnect the cutting deck rod
6. Release the belt tensioner
7. Disconnect the drive belt
8. Pull and lift the cutting deck
9. Lift the cutting deck and release the lock
10. Push into position
11. Connect the cutting deck rod
12. Connect the drive belt
13. Pull the belt tensioner into position
14. Remember to exit service position

Ride-on mower R300-series; service position

1. Lift the cutting deck
2. Put height adjustment lever in service position
3. Engage the parking brake
4. Bring the starter key with the attached tool
5. Remove the cover
6. Release the belt tensioner
7. Disconnect the cutting deck rod
8. Disconnect the drive belt
9. Pull and lift the cutting deck; will automatically lock
10. Lift the cutting deck and release the lock
11. Push into position
12. Connect the drive belt
13. Connect the cutting deck rod
14. Pull the belt tensioner into position
15. Remember to exit service position

To put the cutting deck in a service position

NOTE: Before starting, make sure to turn off the product by setting the power switch to "0" position.

1. Park the product on level ground.
2. Set the cutting height lever in the service position.
3. Release the clip on the front cover with the tool attached to the power switch key, and remove the cover.
4. Lift the cutting height stay and put it in the holder.
5. Disconnect the cable to the cutting deck.
6. Disengage the lock to the cutting deck with your hand. Pull the cutting deck out with the other hand.
7. Lift the cutting deck to a vertical position until you hear a click sound. The cutting deck is locked automatically in the vertical position.

To put the cutting deck in a mow position

1. Hold the front edge of the cutting deck.
2. Loosen the lock with the other hand.
3. Fold down the cutting deck and push it in until it stops.
4. Connect the cable to the cutting deck.
5. Lift the cutting height stay from the stay holder and put it in the hole.
6. Attach the front cover.
7. Move the cutting height lever from the servicing position to one of the position with a number.