Cutting blades do not rotate on a garden tractor
While working with your Husqvarna garden tractor you may notice that the cutting blades are not rotating.
There can be several reasons for the blades not engaging on your garden tractor.
CAUTION: For safety reasons, always wear protective gloves while performing this task. Blades are sharp and injuries can occur easily.
Be seated on the garden tractor's seat
The operator presence system prohibits the blades from rotating if the operator is not present.
Driving in tall grass
If the load is too high on the blades, they will not rotate. Do not use your garden tractor in tall grass.
Dirt and debris stuck in the cutting deck
WARNING: TURN OFF THE PRODUCT, REMOVE IGNITION KEY AND WEAR GLOVES
Check if the blades can move freely. If the blades cannot move freely, remove any debris and obstructions around the blades and in the cutting deck.
Engage the reverse operation system (ROS) function
WARNING: Before and while you operate the product rearward, look down and behind the product for the safety of others.
Petrol-powered garden tractor
- Turn the ignition key counter-clockwise to the ROS position to engage the ROS.
- Slowly push the rearward pedal to start movement.
- Turn the ignition key clockwise to the engine ON (I) to disengage the ROS.
Battery-powered garden tractor
NOTE: If you try to go rearward with the product when the cutting deck is engaged, the product stops immediately. Engage the ROS to go rearward with the product when the cutting deck is engaged.
- Start the product.
- Turning the power switch clockwise to the ROS position to engage the ROS.
- Slowly push down the rearward pedal to start movement.
- Turn the power switch counter-clockwise to "I" position to disengage the ROS.
Correctly installed cutting deck drive belt
NOTE: This refers only to petrol-powered garden tractor.
Cutting blades will stop rotating if the cutting deck drive belt is not installed correctly.
Check if the cutting deck drive belt is correctly installed on your garden tractor
