How to store a ride-on lawn mower
Since Husqvarna offers a wide range of attachments for your ride-on lawn mower, you can use this versatile product throughout the whole year.
In case you have no need for your ride-on lawn mower during a particular time of year, or simply don’t own the attachments, we recommend storing it so the product lasts longer.
When it comes to a battery-powered ride-on lawn mowers, the use of this type of product is not recommended if the temperature is under 0°C and over 38°C.
It is important to keep your ride-on lawn mower clean and prepare it for storage when the season ends. This is vital in order for the product to continue working in optimal conditions during the next season.
Fuel:
In order to prevent tacky particles during storage, it is good to add fuel stabiliser. Add stabiliser to the fuel tank or the container used for storage. Always use the mixing ratio recommended by the manufacturer. After adding the fuel stabiliser, run the engine for a minimum of 10 minutes until it flows into the carburettor.
If you are using alkylate fuel, there is no need to add the fuel stabiliser.
If you are using standard fuel, do not switch to alkylate petrol since this can cause sensitive rubber parts to become hard and brittle.
You can also choose to empty the fuel tank. To do this, start the engine and run it until there is no remaining fuel in the carburettor.
NOTE: If you add fuel stabiliser, do not empty the fuel tank and carburettor.
Cleaning:
WARNING: Remove grass, leaves or other flammable materials from your ride-on lawn mower to decrease the risk of fire. Let the product become cool before you put it in storage.
CAUTION: Do not use a high-pressure washer or a steam cleaner. Water can cause corrosion which results in damage to the product.
- Do not clean hot surfaces such as engine, muffler and exhaust system. Wait until surfaces are cool, then clean the product from grass and debris.
- Before you clean with water, clean with a brush. Remove grass and other debris on and around the transmission, the transmission air intake and the engine.
- Use running water from a hose to clean the product. Do not use high pressure.
- Detergents usually increase the damage.
- To clean the cutting deck, put it in a service position and clean it with a water hose.
How to put a ride-on lawn mower in service position
Other tips:
- Remove the battery. Clean it, charge it and keep it cool during storage.
- Examine the product for worn or damaged parts. Tighten loose screws and nuts.
- Change the engine oil and discard the waste oil.
- Remove the plugs and put about a tablespoon of engine oil into each cylinder. Manually turn the engine shaft to apply the oil and put the plugs back on.
- Lubricate all grease nipples, joints and axles.
- Keep the product in a clean and dry area and cover it for more protection.
Cleaning:
WARNING: Remove grass, leaves or other flammable materials from your ride-on lawn mower to decrease the risk of fire. Let the product become cool before you put it in storage.
- Wait until the surfaces are cool, then clean the product of grass and debris.
- Cleaning a ride-on lawn mower.
NOTE: Ride-on mower R200iX has a general IPX4 rating, which classifies the product's water resistance. Use a brush or compressed air to clean it.
NOTE: Ride-on mower R112iC does not have any general IP classification. Use a brush or compressed air to clean it.
Other tips:
- Fully charge the battery. (100%)
- Examine the product for worn or damaged parts.
- Lubricate all joints and axles.
- Keep the product in a clean and dry area and cover it for more protection. Be sure to keep the product in a room with a temperature above 0°C.
