Automower®27/11/2024

Outside work area – Automower® error message

The message Outside work area is shown when the robotic lawn mower detects a loop signal that claims the product is outside, not inside, the work area.

Common causes:

  • The boundary wire is placed too close to a slope or other obstacle (should normally be a minimum margin of 35 cm).
  • The boundary wire is connected to the wrong pin in the charging station (causing the loop signal to be "outside-in").
  • The boundary wire is installed in the wrong direction around an island (causing the loop signal to be "outside-in").
  • The virtual boundary (for EPOS™ models) is placed too close to a slope or other obstacle.

Our Product Assistant can help you find the solution for your specific case.

Open product assistant

Was this article helpful?

Robotic Lawn Mowers

(27)